NavCom LAND-PAK Rev.F - Manual (Page 30)

LAND-PAK™ User Guide – Rev. F
1-28
Each port conforms to the EIA RS-232 standard.
Available data rates are from 1.2 to 115.2kbps for the
serial ports. The USB port operates at 2.0 Mbps.
Refer to the supplied SF-3040 GNSS
Product User Guide for further
information about the SF-3040 ports.
The SF-3040 GNSS receiver is Bluetooth-capable.
The Bluetooth module permits cable-less operation
between the receiver and the Nautiz X8 data
controller, with less than 0.2% data loss. Wireless
connectivity is provided within a range of 5 m (16 ft)
once a connection is established, and a data rate of
230.4 Kbps is supported, 10 Hz maximum. The initial
paring sequence must be conducted within 2m (6ft) of
the SF-3040. The Bluetooth interface allows
interleaved RTK data from a data collector GSM radio
modem and SF-3040 data positioning (i.e., two
communication links on one port).
Base Station and Rover Radio Modems
The LAND-PAK Survey System includes two internal
UHF radio modules that output up to 1W of power in
the 403 to 473 MHz band. The radios are digitally
synthesized and can be tuned to any in-band
frequency in 12.5 or 25 KHz steps. An optional 35W
booster is available for the base station, but must be
ordered at the desired center frequency.
Set the radio modems only to a
licensed frequency. It must comply
with local regulatory authorities.
It is the user’s responsibility to acquire
all necessary radio licenses prior to
operation.