Skutch Electronics BA-1000 V2.90 - Manual (Page 26)

Version 2.90 Page 26
Pressing 1 will have the system load the setup
defaults from a previously saved file on the ZIP
disk, and the display will show the following:
Loading Defaults
- Please Wait –
Pressing 3 will have the system save the setup
defaults to a file on the ZIP disk, and the display will
show the following:
Saving Defaults
- Please Wait –
The system will then return you to the initial
load/save screen when done.
• Line Feed
This option allows you to turn the automatic
line feed option, for a connected printer, on/off.
When On, the system will print a line of data, then
send a carriage return and line feed. When Off it
sends just a carriage return and relies on the printer
to perform the line feed. The display looks as
follows:
Printer LF= On
1=Change #=Next
Press 1 to toggle between On and Off; press #
to go to the next option. You can press Escape to
exit setup mode.
• Dial Mode
This option allows you to select touch tone
dialing or pulse dialing. Some phone lines still only
allow pulse dialing for outbound calls; in these areas
you can change the system to pulse dial mode. The
display looks as follows:
Dial Mode= Tone
1=Change #=Next
Press 1 to toggle between Tone and Pulse;
press # to go to the next option. You can press
Escape to exit setup mode.
•
Consent Mode
This option allows you to change how the
system uses the touch tone consent mode. When
you make your outgoing message, one of the codes
you can use is the Tone Consent code. When the
system encounters a Tone Consent code during a
call, it will wait for the called party to press a touch
tone digit. With this option set for Play mode, the
system will continue with the outgoing message
when it receives a touch tone input; it will hang up if
it doesn’t. When set for Stop mode, the system will
hang up if it receives a touch tone input; it will
continue with the outgoing message if it doesn’t.
The display will look as follows:
Consent #= Play
1=Change #=Next
Press 1 to toggle between Play and Stop; press
# to go to the next option. You can press Escape to
exit setup mode.
• Transfer Beep Mode
This option allows you to turn the transfer
beeps on/off. A transfer beep is a tone the system
plays to the called party after each transfer code
during message play out. When this option is On,
the system will play a beep after each question.
When Off, it won’t beep at the called party; this
makes it seem more like a live person is asking the
questions. The display will look as follows:
Xfer Beeps= On
1=Change #=Next
Press 1 to toggle between On and Off; press #
to go to the next option. You can press Escape to
exit setup mode.
• Pulse Dial Rate
This option allows you to change the system
between slow pulses and fast pulses when it is in
pulse dial mode. With the option set to Slow, the
system will dial pulse digits at the standard 10
pulses-per-second rate. When set to Fast, the
system dials pulse digits at 20 pulses-per-second;
this makes for faster dialing, but not all phone
companies accept this rate. The display will look as
follows: