Skutch Electronics BA-1000 V2.90 - Manual (Page 29)

Version 2.90 Page 29
When the operator is done talking, he must
hang up the phone and press 1 to play the message
(only during front attended) or 3 to drop the call and
proceed to the next call.
0 = Unattended
Unattended mode is used when you don’t want
an operator to talk with the called party.
1 = Front Attended
Front attended is used to have an operator talk
with the called party before the message is played
out.
2 = End Attended
End attended is used to have an operator talk
with the called party after the message has played.
3 = Both Attended
Both attended is used to have an operator talk
with the called party both before the message is
played and after it is played.
The display will look as follows:
Attended= Off
0 to 3 #=Next
Press 0 for Unattended, 1 for Front Attended, 2
for End Attended, 3 for Both Attended or press # to
go to the next option. You can press Escape to exit
setup mode.
• Redials
This option tells the system how many times it
can re-call No Answers and Busies. The system
only performs redials after it has called the last entry
in the file. The display will look as follows:
Redials= 02
00 to 99 #=Next
Enter from 00 to 99, 00 doesn’t allow the
system to do any redials; press # to go to the next
option. You can press Escape to exit setup mode.
• Talk Limit
This option tells the system how many seconds
of continuous talking it can accept, before it
considers the call a Recorded Message. For this
option, 1 = 1 second. The display will look as
follows:
Talk Limit= 30
00 to 99 #=Next
Enter from 01 to 99 then press # to go to the
next option. You can press Escape to exit setup
mode.
• Talk Pause
This option tells the system how many seconds
of silence it needs in order to stop recording and
continue with the outgoing message. For this
option, 1 = .1 seconds. The display will look as
follows:
Talk Pause= 20
00 to 99 #=Next
Enter from 01 to 99 then press # to go to the
next option. You can press Escape to exit setup
mode.
• Sense Level
This option lets you manually set the sensitivity
level for the system’s answer detect. This value
should NOT be adjusted unless instructed to by a
Skutch Service Technician.
Sense Level= 10
01 to 19 #=Next
Enter the level from 01 to 19 then press # to go
to the next option. You can press Escape to exit
setup mode.
• Pre-Dial String
This option allows you to enter a master dialing
string that the system will dial before it dials each
phone number. You cannot put a partial dialing
code in the pre-dial string. The display will show
the following for 1 second, show the string for 1
second and keep repeating.
Pre-Dial String
1=Change #=Next