Skutch Electronics BA-1000 V2.90 - Manual (Page 5)

Version 2.90 Page 5
Current File = N
#=Next 0-9 or *
16) Enter: 0 then Escape and it will show the
following:
0-Menu-Ver 2.9-A
–Press a Number-
• Play your Responses
1) Press Escape and wait until it shows the
following:
0-Menu-Ver 2.9-A
–Press a Number-
2) Enter: 9 then # and it will show the following:
0=Play <<00000>>
1=Back 2=Advance
3) From this screen, you can: play your responses
by pressing 0, skip a response by pressing 2, or
go back to the last response by pressing 1. It
will play each response, one after the other, until
it has played all of them. The system will beep
at you 4 times after playing the last response.
You can stop the playback of any response by
pressing Escape.
4) To exit, you need to be at the following screen:
0=Play <<00000>>
1=Back 2=Advance
5) Press Escape and it will show you the
following:
Erase ALL Leads?
1=Yes 3=No
6) Press 1 to erase the leads, or 2 if you want to
save them for later.
7) When the system is done, it will return to the
MENU.
• Disable Caller ID
You can stop Caller ID information from being
sent, using either of two ways: 1 st way, call your
local phone service provider and request to have a
“Permanent Caller ID Block” put on your line, 2 nd
way, do the following steps.
1) Press Escape and wait until it shows the
following:
0-Menu-Ver 2.9-A
–Press a Number-
2) Enter: * then # And it will show the following:
Set CURRENT Time
1=Change #=Next
3) Now, slowly # step (press #, wait 1 sec, then
repeat) your way to the entry shown below.
Pre-Dial String
1=Change #=Next
4) Now press 1 then <PAUSE>.
5) Enter: *, 3, 6, 7, *, 1, #.
6) Now press Escape and you are done, it will
automatically dial *67 and wait for return dial
tone before dialing each phone number.
• Stop Dialing For A Given
Day
To keep the system from dialing on some day
during the week, do the following:
1) Press Escape and wait until it shows the
following:
0-Menu-Ver 2.9-A
–Press a Number-
2) Enter: * then # and it will show the following:
Set CURRENT Time
1=Change #=Next
3) Press # and it will show the following:
Set DIALING Time
1=Change #=Next
4) Press 1 and it shows the following:
Enter day, 1 – 7
#=Sunday