Teac MX-2424 Tutorial - Manual (Page 22)

- 22 -
FIRST SESSION FIRST SESSION FIRST SESSION FIRST SESSION
Loading the Factory Demo
The MX-2424 doesn't automatically load a project when it is powered up. It leaves the
decision of which project you want to load up to you. If you have just connected your
MX-2424 to your mixing board, it can be helpful to load the MX-2424 Demo Song to
become familiar with the MX-2424’s operation. This will also give you 24-tracks of
music to check all of your connections.
Loading the Factory Demo Song
1) Turn your MX-2424 on using the rocker type power switch on its face. Give it a
minute to boot up. You will see the message, "Mounting Volumes," on the LCD. When it
is finished booting and ready to run, the LCD will read,
MX-01 01:00:00:00
00:00:00:00
2) Press [PROJ/NEW]. The button's associated LED will light and the [STORE/YES]
LED will flash. The LCD will read,
Load
* Select Action
3) Press [STORE/YES]. Then use the [Up Arrow] or [Down Arrow] to scroll to the
project titled, "Warmness.tl" (if this is the very first time you have booted your MX-2424,
it may be the only project listed or by the time you read this, there may be a different
project pre-loaded). The LCD screen should look like this,
Load Project
Warmness.tl [0:23]
4) Press [STORE/YES]. You will hear the hard drive working and the DISK LED will
illuminate for a few seconds as your MX-2424 loads the project.
5) Double click the [REW] button and press [Play] to have a listen.
• HOT TIP! — To load any project, follow Steps 1 to 4. But instead of choosing the
Demo Song in Step 3, select a different project to load.