Teac MX-2424 Tutorial - Manual (Page 27)

- 27 -
Record!
If you have followed all the steps so far, you are ready to record your first tracks. Don't
worry too much about recording a perfect signal right away - just get something
recorded to disk. Recording technique can be perfected with time and practice.
Recording Tracks
1) Use the Track Select buttons to arm the track, or tracks, you want to record on.
2) Send some audio from your mixer to the MX-2424's input. You should see a level,
representing the incoming signal, on the record enabled tracks’ meters. Be sure the
outputs of the MX-2424 are connected to playback channels of your mixer in order to
hear the recorded sound.
3) Adjust the incoming signal so that the peaks do not exceed 0 dB on the track meters.
4) Enter 01:00:00:00 on the numerical keypad and press [LOCATE] to cue up the
transport for beginning a project at one hour.
5) Press and hold [Play]. And when you reach the spot where you want to begin
recording, press [Record]. The track record enable lights will change from blinking to
solid, to let you know recording is in progress.
6) When you are done recording, press [Stop].
7) That's it, your tracks are recorded. Double-tap the [Rew] button to rewind to the top
of the recording and have a listen.