Teac MX-2424 Tutorial - Manual (Page 24)

- 24 -
Choosing The Project’s Parameters
Certain decisions must be made before recording audio. These are decisions that
affect the way the actual audio files are recorded and whose settings are stored as part
of the project. After creating a new project but before recording audio, make sure the
following parameters are set to the desired values. Keep in mind that the default
settings may be acceptable for your application.
Selecting a Sample Rate
1) Press [SETUP].
2) Press [0] on the numeric keypad and then use the [Up Arrow] to scroll to system
page #005. You will see,
005 Sample Rate
* 44100
3) Press [TRIM].
4) Use the [Up Arrow] to scroll to your desired sample rate. For example,
005 Sample Rate
96000
5) Press [STORE/YES] to set the new sample rate. An asterisk will appear in front of
the new rate to let you know it's active. It should look like this,
005 Sample Rate
* 96000
• HOT TIP! — If you tend to record at a sample rate other than 44.1 kHz on a regular
basis, you may want to set a different sample rate as your MX-2424's default. Press [9]
to jump to system page #900 ("Store Settings") and press [STORE/YES]. This stores
the new sample rate as your default.