Verilink DPRI 2922 (880-503142-001) Product Manual - Manual (Page 65)

Configuring the DPRI 2922 Via the NCM 2000 Craft Interface
Verilink DPRI 2922
3-35
Net Port Alarm
Threshold
Configuration
Menu
The Performance/Status Menu reflects the industry T1 standard
thresholds, while the Net Port Alarm Threshold Configuration
Menu enables setting custom alarm thresholds and intervals in
addition to the above standards.
To view and modify the alarm thresholds, enter C from the Net
Port Alarm Menu to display the Net Port Alarm Threshold
Configuration Menu. Use this menu to set the monitoring interval
for several types of alarms and the alarm threshold for errored
seconds within the monitoring interval.
For example, if the LOF interval is set to 100 seconds, and the LOF
threshold is set to 5 seconds, then an alarm will be sent if more
than 5 errored seconds occur during a 100-second interval. The
errored count resets to zero after the end of the interval, unless
there is an alarm condition, and the first second of the next interval
is also errored. The alarm state continues until a new interval
contains no errors in the first second.
Figure 3-26 Net Port Alarm Threshold Configuration Menu
NOTE: To disable any or all alarm conditions, enter a threshold value of 0.
To enable a condition, specify any non-zero threshold value. The
interval must be greater than or equal to the threshold value.
-- DPRI 2922 NET PORT ALARM THRESHOLD CONFIGURATION MENU --
PORT 1 PORT 2
Pn) Alarm Reporting(NET) NO NO
Dn) Alarm Reporting(DATA) NO NO
Fn) LOF threshold 3 3
LOF interval 3 3
Ln) LOS threshold 3 3
LOS interval 3 3
Rn) RAI threshold 1 1
RAI interval 1 1
An) AIS threshold 1 1
AIS interval 1 1
Bn) BPV threshold 1 1
BPV interval 1 1
En) ES 15min threshold 900 900
ES 24hr threshold 86400 86400
Sn) SES 15min threshold 900 900
SES 24hr threshold 86400 86400
In) BER threshold DISABLE DISABLE
X) exit this screen
[0.0.0.5] [1,2] DPRI 2922 >