Verilink DPRI 2922 (880-503142-001) Product Manual User Manual
Page 71
Configuring the DPRI 2922 Via the NCM 2000 Craft Interface
Verilink DPRI 2922
3-41
Figure 3-29 Add Circuit Submenu
Table 3-24
Add Circuit Submenu Commands
Command
Description
Options
N
Name—Circuit name (Circuit ID
12 characters
maximum
P
Priority—
1) low
2) norm
3) high
4) crit
T
Type—Circuit type.
1) perm
2) swit
3) prim
4) d-bk
5) bkup
M
Mode—Circuit Mode
1) 64K
2) 56K
For Subrate DIU
only:
3) 38.4K
4) 19.2K
5) 9.6K
6) 4.8K
7) 2.4K
SP
Source Port—Displays the Node “Map” and prompts for the SRC Port shelf,
slot. Use this option to designate the starting point of your circuit. Once
the Shelf and slot position of the Source Port has been entered, you are
prompted with 4 choices.
1) net1
2) net2
3) dat1
4) dat2
DP
Destination Port—Displays the Node “Map” and prompts for the DEST Port
shelf, slot. Use this option to designate the ending point of your circuit.
Once the Shelf and slot position of the Source Port has been entered, you
are prompted with 4 choices.
1) net1
2) net2
3) dat1
4) dat2
SM
SRC Port Chn—Source Timeslot. Designate which T1 timeslots you wish to
use in this circuit.
Note: In ISDN, timeslot 24 is normally reserved for use in D-channel call
set-up. For this reason, avoid building circuits which use timeslot 24.
For ISDN, a call-reference option is provided to designate the call profile
for backup.
1—24 or press
ENTER
to exit
A [127.255.255.0] [1,2] DPRI 2922 > a
Add Circuit -- [1,1] NCM 2000 Firmware 4.15 --
N) Name: -- P) Priority: norm
T) Type: -- M) Mode: --
SP) [-,-] undefined DP) [-,-] undefined
SM) --src port chn-- DM) --dst port chn--
(undefined port) (undefined port)
(undefined port) (undefined port)
(undefined port) (undefined port)
(undefined port) (undefined port)
U) Bus: -- ->-->>->> Circuit Inactive <<-<<--<-
S) Setup X) Exit
A [127.255.255.0] [1,2] DPRI 2922 >