Verilink HDM 2180 (880-503048-001) Product Manual - Manual (Page 25)

Verilink HDM 2180 User Manual 3-1
Chapter
3
Standalone HDM 2180 Management
This chapter describes the Craft interface menu options for a
standalone HDM 2180 (no NCM 2000 controller module used for
management). See
Chapter 4 for HDM features using an NCM 2000
for management.
Using the Local Port
To access the HDM 2180 from an ASCII terminal:
1. Connect your ASCII terminal to the front panel Local port.
2. Set your terminal parameters to the following values:
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop-bit
• no flow-control
Be sure that X- ON
/ X- OFF
flow control is disabled.
3. Type “craft” and press E NTER .
4. At the PASSWORD: PASSWORD: PASSWORD: PASSWORD: prompt, type “verilink” (in lower case) and
press E NTER .
The HDM 2180 Craft Interface Main Menu (Main Menu) is
displayed.
HDM 2180 Craft Interface, Main Menu
The Main Menu is the starting point for all management tasks
accessed directly through the HDM 2180 Craft interface. The menu
title displays information such as the name and shelf/slot position
of the HDM 2180 module, its firmware version, and date/time. The
menu, with an explanation of each option, follows.