Power components – H3C Technologies H3C S12500 Series Switches User Manual
Page 135
125
Model Interfaces
Supported interface modules
LST1FW3A1
•
One console port
•
One CF card slot, supporting a 256M CF card
•
Two USB ports (reserved for hardware, not
supporting software)
•
Two GE combo interfaces
GE SFP modules
LST1IPS1A1
•
One console port
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
GE SFP modules
LST1NSM1A1
•
One console port
•
One CF card slot, supporting a 256M, 512M,
or 1G CF card
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
GE SFP modules
LST1LB1A1
•
One console port
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
GE SFP modules
LST1ACG1A1
•
One console port
•
One CF card slot, supporting a 256M, 512M,
or 1G CF card
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
GE SFP modules
Power components
Select AC or DC power components according to the power supply mode of your switch.
•
Choose power supplies based on your actual needs. Make sure the maximum output power of the
power supplies exceeds the system power consumption (H3C recommends reserving a certain
power de-rating value). For the maximum output power of a single power supply, see
•
H3C recommends you to configure N+1 or N+M power supply redundancy.
•
To use AC power supply, select the specific 16 A AC power cords. For the 16A AC power cords
used in different countries or regions, see
.
Table 41 Power system ordering guide
Model
Power supply
mode
Power components
Configured quantity
PSE9000-A1
AC
AC power frame
•
1 for the S12504 or S12508
•
2 for the S12518