H3C Technologies H3C S12500 Series Switches - Manual (Page 34)

24
NOTE:
The number of screws and nuts supplied with the switch depends on those shipped from the factory.
User-supplied tools and equipment
• Mechanical lift
• Phillips screwdriver P1 – 100 mm, P2 – 150 mm, and P3 – 250 mm
• Flat screwdriver P4 – 75 mm
• Marker
• Tape
• Diagonal pliers, wire-stripping pliers, and wire clippers
• Socket wrench
• Cables such as network cables and fiber cables
• Meters and equipment, such as hub and multimeter
• Configuration terminal, such as PC
NOTE:
The rack accessories and installation tools are not included in this section. The accessories and installation
tools may vary depending on the rack model. For more information, see the installation guide of the
corresponding rack.