Grass Valley K2 Solo 3G Client Service Manual v.9.0 - Manual (Page 49)

Restoring network configuration
When you restore a system from its system specific image, network configuration is also restored
to the factory default settings. This is the recommended method of restoring network configuration.
However, if for some other reason you must configure network settings manually, use the tasks in
this section to restore the default network configuration.
Create the Control Team
Before beginning this task, make sure of the following:
• Adapters are named
NOTE: Team control ports only. Do not team media ports.
1. If K2 software is installed, disable the write filter, if it is not already disabled.
2. Open Network Connections, if it is not already open.
3. In Network Connections, in the Device Name column, identify the adapter name that maps to
Control Connection #1 and the adapter name that maps to Control Connection #2.
4. In Device Manager, right-click the adapter name that maps to Control Connection #1.
5. Select Properties
The Properties dialog box opens.
06 November 2012 K2 Solo 3G Service Manual 49
Service procedures