Grass Valley K2 Solo 3G Client Service Manual v.9.0 - Manual (Page 67)

1. Restore network configuration. If you saved settings with ssave.bat , refer to C:\ipconfig.txt
for the complete listing of the network settings that the K2 Solo 3G system had before reimaging.
2. Install the SiteConfig Discovery Agent.
3. If you install software with SiteConfig, do the following:
• Take Embedded Security out of Update mode.
• Install SNFS software and K2 software using SiteConfig.
• Restore SabreTooth licenses.
4. If you install software manually (without SiteConfig), do the following:
• Install SNFS software and K2 software manually.
• Take Embedded Security out of Update mode.
• Restore SabreTooth licenses.
If you saved/restored settings with ssave.bat and srestore.bat , SNFS uses the restored settings.
Refer to related topics in "K2 Release Notes".
5. Check the Windows operating system clock, and if necessary, set it to the correct time.
6. Activate Windows within 30 days.
Related Topics
Embedded Security modes and policies on page 46
Installing the Discovery Agent on a K2 Solo system
If the device that you plan to manage with SiteConfig does not have a SiteConfig Discovery agent
installed, use this topic to verify and, if necessary, manually install SiteConfig support software.
Doing so allows SiteConfig to discover and manage the device. If the device has any version of the
SiteConfig Discovery Agent currently installed, you should use SiteConfig to upgrade the Discovery
Agent, rather than installing it manually.
1. On the device you plan to manage with SiteConfig, open the Windows Services Control Panel
and look for the following required item:
• ProductFrame Discovery Agent
2. Proceed as follows:
• If you find the required items, no further steps are necessary. SiteConfig support software is
installed.
• If a required item is not present, navigate to your SiteConfig files. If you do not already have
these files in convenient location, you can find them on the PC that hosts SiteConfig, in the
SiteConfig install location. Then continue with next steps as appropriate.
3. To launch the program that installs the ProductFrame Discovery Agent Service do the following:
a) Copy the Discovery Agent Setup directory to the device.
b) In the directory, double-click the DiscoveryAgentServiceSetup.msi file.
The setup program launches to install the SiteConfig Discovery Agent.
c) Follow the setup wizard.
4. When presented with a list of device types, select the following:
• K2SoloStandaloneClient
06 November 2012 K2 Solo 3G Service Manual 67
Service procedures