Grass Valley K2 Solo 3G Client Service Manual v.9.0 - Manual (Page 66)

14. On the Restored Partition Type page, select Active and then click Next .
15. Do one of the following:
• If the Restored Partition Size page does not appear. Skip ahead to the Next Selection page.
• If the Restored Partition Size page appears. Continue with the next step.
16. On the Restored Partition Size page, do one of the following:
• If Free space after reports 0 bytes, leave settings as they are. Click Next .
• If Free space after does not report 0 bytes, increase Partition size until Free space after reports
0 bytes. Click Next .
17. On the Next Selection page, select No, I do not and then click Next .
18. On the Restoration Options page, do not make any selections. Click Next .
19. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed .
20. On the Operation Progress page, observe the progress report.
21. When a message appears indicating a successful recovery, click OK .
22. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
23. Remove the recovery media while the machine is shutting down.
24. Upon startup, wait for initialization processes to complete. This can take several minutes, during
which time USB keyboard/mouse input is not operational. The system might automatically restart.
Do not attempt to shutdown or otherwise interfere with initialization processes.
25. When prompted, enter the K2 Solo 3G system machine name.
Make sure the name is identical to the name it previously had.
After start up, one or more device discovery windows can open. Allow processes to complete
without interference. If a Fibre Channel card driver, ignore until instructed later in this process.
At first start up after reimage, the system is in Embedded Security Update mode by default.
Next, check the adapter names and order. If adapter names and order are not as documented, restore
network configuration.
Restoring settings after generic reimage
This task assumes that you have saved settings using ssave.bat before reimaging the K2 Solo 3G
system, and that the reimage (Acronis) process is complete.
1. If you have not already done so, start up the K2 Solo 3G system and log on with administrator
privileges.
The administrator password is adminGV! .
2. Connect the USB Recovery Flash Drive to a USB port on the K2 Solo 3G system.
3. From the USB Recovery Flash Drive, run the following and wait for the process to complete:
Tools\SaveRestoreScripts\srestore.bat
Next, do the following as appropriate to restore your K2 Solo 3G system. Refer to related topics in
this document or as otherwise indicated.
66 K2 Solo 3G Service Manual 06 November 2012
Service procedures