Grass Valley XtenDD v.4.2.4 User Manual
Page 401
3. Menu Operation
3 – 254
Operating Instructions – Rev. 1 / 7.2002
Recursion is not possible:
P/P
→
M/E3; M/E3
→
P/P
NOT ALLOWED!!
Each ME can be used as Master M/E. If a coupled M/E is modified directly via a
control unit the master ME is not affected.
Coupled recources:
After selection the M/E Couple Mode in the Config EBox menu, the following M/E
resources can be coupled:
D
PGM and PST bus (optionally by one substitution table) at M/E crossbar
D
CUT, AUTO and FADER at M/E transition.
By selecting M/E Couple in the Status menu, additional the following function can
be coupled:
D
Fill busses of the keyers. Together with the key memory, most keyer adjust-
ments can be recalled (no wipes...)
D
M/E coupling can be (de)activated for each resource)
TiM/E-Memo handling:
ME coupling works on command level. This means that TiM/E-Memo recalls and
application load are disregarding M/E coupling. It is used to preset M/Es.
Applications:
Every application has its own, complete M/E-coupled structure. If an application is
loaded or the coupled state of one application is changed, this new modification is
checked and accepted or rejected (see Coupling rules).