Grass Valley XtenDD v.4.2.4 - Manual (Page 426)

3. Menu Operation
3 – 279 Operating Instructions – Rev. 1 / 7.2002
Analog value (e.g. Wipe Border Width):
set by value Sets border width to a fixed value.
Next selection will allow you numeric entry.
set to minimum
Sets the border width to minimum
set to maximum
Sets the border width to maximum
set to neutral Some analog value like the border width have a symmetrical
range (+/–). Set to neutral selects the middle position.
increment allows you to create a macro which increases/decreases the value
by a certain amount any time you execute the macro.
Analog commands can only be created directly in the command
editor. Via the control panel you can not learn analog macros.
An interesting analog macro could be e.g. the following:
This macro will always set Dsk1 to “on”.
A macro learned on the control panel with “Cut” or “Auto” instead will toggle the
state of the Dsk.