Grass Valley XtenDD v.4.2.4 - Manual (Page 99)

2. Panel Operation
2 – 70 Operating Instructions – Rev. 1 / 7.2002
Multi The Multi key serves to enable the wipe pattern multiplication
function.
The following adjustments are possible:
H horizontal multiplication
V vertical multiplication
O multiplication in radial direction, only for closed
wipe patterns (e.g. circle)
X number of rays for the star wipe and flower.
Wipe Rot The Wipe Rot key serves to enable the wipe pattern rotation.
The following adjustments are possible:
ANGL setting a fixed rotation angle
SPD setting the rotation speed
COUP rotation angle depending on fader position. The
number of rotations can be selected with the
control.
Bord The Bord key serves to enable the wipe pattern border function.
The following adjustments are possible:
WIDTH border width adjustment. The border width may
be adjusted by clockwise or counter-clockwise
rotation.
If the border is made transparent with Opac, the
direction of rotation of the border width control
determines which picture component will be seen
in the border.
OPAC adjustment of the transparency
If the Soft modifier is also enabled, the following additional adjust-
ments are possible:
SOFT adjustment of the border softness
SYM adjustment of the softness symmetry
Soft The Soft key permits adjusting the softness of the wipe edge.
The following adjustments are possible:
SOFT adjustment of the softness width
If the Bord modifier is also enabled, the following additional adjust-
ments are possible:
WIDTH adjustment of the border width
OPAC adjustment of the transparency
SYM adjustment of the softness symmetry