Yaskawa RC5 Converter - Manual (Page 13)

1.2 Inspection Checkpoints
YASKAWA ELECTRIC TOEP C710656 01C YASKAWA - RC5 Instruction Manual 13
1.2 Inspection Checkpoints
◆ Receiving Checkpoints
Table 1.1 Checkpoints
If any of the above checkpoints are not satisfactory, contact your YASKAWA representative.
◆ Checking the Nameplate Data
■ Nameplate Data
Example of standard domestic model CIMR-R5U2011.
Figure 1.1
Figure 1.1 Nameplate Data
■ Model Designation
Figure 1.2
Figure 1.2 Model Designation
■ Protective Structure
• Open Chassis Type (IEC IP00)
Protected so that parts of the human body cannot reach electrically charged parts from the front when the Power regenerative unit is mounted in a
control panel.
• Enclosed Wall-mounted Type (IEC IP20, NEMA 1)
The power regenerative unit is structured so that the power regenerative unit is shielded from the exterior, and can thus be mounted to the interior
wall of a standard building (not necessarily enclosed in a control panel). The protective structure conforms to the standards of NEMA 1 in the
USA.
Checkpoints Description
Does the power regenerative unit model number correspond with the
purchase order?
Check the model number on the nameplate on the side of the RC5. (Refer to Figure 1.2 .)
Are any parts damaged? Visually check the exterior and verify that there was no damage during transport.
Is hardware properly seated and securely tightened?
Remove the front cover of the power regenerative unit.
Check all visible hardware with appropriate tools.
Voltage
2 3-phase 200 V class
4 3-phase 400 V class
CIMR - R5 U 2 011 1 A
Power Regenerative
Unit
VS - 656RC5 Series
Symbol Max. applicable motor output
3P7 3.7kW
5P5
to
37
5.5kW
to
37kW
Symbol
Symbol
U
Specifications
Standard domestic model
Version (Enter the specifications
form number when special speci-
fications are required.)
No. Protective Structure
Enclosed wall-mounted
(IEC IP20, NEMA1)
0 Open chassis (IEC IP00)
1
“P” indicates the decimal point.
A Japan standard model