Yaskawa RC5 Converter - Manual (Page 39)

4.5 Digital Operator Modes
YASKAWA ELECTRIC TOEP C710656 01C YASKAWA - RC5 Instruction Manual 39
4.5 Digital Operator Modes
This section describes the RC5’s monitor modes, switching between modes, and accessing/setting user parameters.
◆ Modes
The RC5’s user parameters and monitoring functions have been organized in groups called modes that make it easier to read and set user parameters.
The RC5 is equipped with 4 modes, as shown in
Table 4.2 .
Table 4.2 Modes
Mode Primary function(s)
Operation mode
The power regenerative unit can be run in this mode.
Use this mode when monitoring values such as frequency references or output current, displaying fault information, or
displaying the fault history.
Initialize mode
Use this mode when selecting the language displayed on the Digital Operator, selecting the access level for reading/
setting user parameters, selecting the control mode, or initializing the user parameters.
Factory setting: English (A1-00=0)
Programming mode
Use this mode when reading/setting the user constants required for operation.
The program mode functions are subdivided into the following groups:
• Application: Operation mode selection
• Tuning: No Auto-Tuning
• Option: No Option Card support
• Terminal: Settings for sequential I/O and analog I/O
• Protection: Settings for the motor and power regenerative unit protection function
• Operator: Selects the Digital Operator’s display and Key function
Modified constants mode Use this mode to read/set user parameters that have been changed from their factory set values.