Rose Electronics UltraLink 2 - Manual (Page 14)

10 UltraLink 2 Installation and Operations Manual
Change the IP address, network mask, and other network information that has been
assigned to the UltraLink 2. The VNC port (5900) and HTTP Port (80) should only be
changed if they conflict with existing network settings. If you choose to use DHCP, check
the box adjacent to “Use DHCP”. When complete “Save” the new IP information.
NOTE: When the unit is configured properly and connected to the network, if you have
chosen the option “Use DHCP” the IP address will change to whatever IP address your
DHCP server assigns it.
When complete, change the IP information on the computer used to connect to the
UltraLink 2 back to the original values.
Method #3 - Unit configuration via Local KVM station
(dual access model only)
To configure the network information using method #3, connect the UltraLink 2 unit as
shown below. This procedure only applies to the dual access model.
1. Connect a local keyboard,
monitor, and mouse to the
top ports on the UltraLink 2.
2. Connect the supplied CPU
adapter cable from the
bottom ports on the
UltraLink 2 to a standalone
computer.
3. Boot the computer.
4. When the boot-up sequence
is complete, you should see
a logon screen on the KVM
monitor.
5. Enter the user ID “admin”
and no password.
6. The connected computer’s
video should display
Figure 5. Configure Dual model
From the local keyboard, press the Ctrl, Alt, and “C” keys simultaneously. This will display
the configuration menu as shown below.
1. Using the up / down
arrow keys, select “Unit
Configuration” and press
enter.
2. The Unit configuration
window will display.
3. Enter the Unit
information as described
below.
Configuration Menu