Rose Electronics UltraLink 2 - Manual (Page 4)

DECLARATION of CONFORMITY
Declaration of Conformity
This equipment generates, uses and can radiate radio frequency energy and if not installed
and used properly, that is in strict accordance with the manufacturer’s instructions may
cause interference to radio communication. It has been tested and found to comply with
the limits for a Class A digital device in accordance with the specifications Subpart J of Part
15 of FCC rules, which are designed to provide reasonable protection against such
interference when the equipment is operated in a commercial environment. Operation of
this equipment in a residential area is likely to cause interference, in which case the user at
his own expense will be required to take whatever measures may be necessary to correct
the interference.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
European EMC directive 89/336/EEC
This equipment has been tested and found to comply with the limits for a class A computing
device in accordance with the specifications in the European standard EN55022. These
limits are designed to provide reasonable protection against harmful interference. This
equipment generates, uses, and can radiate radio frequency energy and if not installed and
used in accordance with the instructions may cause harmful interference to radio or
television reception. However, there is no guarantee that harmful interference will not occur
in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is
encouraged to correct the interference with one or more of the following measures:
(a) Reorient or relocate the receiving antenna.
(b) Increase the separation between the equipment and the receiver.
(c) Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
(d) Consult the supplier or an experienced radio/TV technician for help.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le règlement sur le
brouillage radioélectriques publié par le ministère des
Communications du Canada.
Radio Frequency Energy
A Category 5 (or better) twisted pair cable must be used to connect the UltraLink 2 unit in
order to maintain compliance with radio frequency energy emission regulations and ensure
a suitably high level of immunity to electromagnetic
disturbances. All other interface cables used with this equipment must be shielded in order
to maintain compliance with radio frequency energy emission regulations and ensure a
suitably high level of immunity to electromagnetic disturbances.