Rose Electronics UltraLink 2 - Manual (Page 35)

UltraLink 2 Installation and Operations Manual 31
The first time you connect to the UltraLink 2 or switch CPU ports if connected to a KVM
switch, the cursors may be out of sync. Click on the Calibration tab on the toolbar and
calibrate the Video + Mouse. After the calibration is complete, the mouse cursors will
follow each other over the VNC viewer window.
Figure 19. VNC Viewer Toolbar
Controls Tab
When you click on the “Controls” tab, the below dropdown menu will display.
Single Mouse Mode
This mode is for fast network connections where the cursor response is sufficient to provide
instant visual feedback on the remote screen. When enabled, the cursor is ‘captured’ within
the viewer window until you use the ‘escape’ hot keys. To escape from the single mouse
mode, press F8 and then P. The single mouse mode does not require calibration and
available only when using the VNC viewer.
Resync Mouse
This option has the same effect as the button on the menu bar and resynchronizes the local
and remote mouse pointers.