TA Triumph-Adler FAX 930 - Manual (Page 10)

5
1
Fax machine (wrapped in plastic film)
Paper tray for scanned documents
Scanner feeder
Printer tray
Printer paper guard
Telephone line cord
User guide
Paper tray cover
Photosensitive drum
FREE printer toner cartridge for up to 700 pages + toner gauge
card
2. INSTALLATION
POSITIONING YOUR UNIT
When choosing the location of your fax machine, you should take the following points into account:
- The telephone socket should be located less than 2 metres from your fax machine, otherwise you will require an
extension cord.
- To provide easy access to the fax machine, ensure there is clearance of around 10 cm on either side and to the rear
of the unit. The front of the unit should always be kept unobstructed.
- Do not expose the unit to direct sunlight, or position it close to sources of heat such as radiators, air conditioning
facilities and, as a general rule, to any excessively hot, dry, humid or dusty environment.
- Avoid exposing the unit to strong vibrations.
- Avoid environments where the unit is likely to come in contact with water or other foreign matter.
- Avoid touching the heat element and do not attempt to remove the internal panels (laser beam).
- Allow the heat element to cool for a few minutes prior to changing the toner cartridge.
FITTING THE PAPER TRAY
b
c
1- Remove the fax unit from its plastic packaging.
Fit the paper guard (a) by positioning the two pins
(b) into the slots (c) of the paper tray at the angle
shown.
Swivel the paper gard (a) round to its rear
position.
a
2
2- Fit the paper tray cover (d) by slotting the two
joints (e) into the pins (f) of the paper tray at the
angle shown.
e
f
d
CHAPTER 1: INSTALLATION
1. UNPACKING THE UNIT
Check for the following contents:
CH00-01 23228395-7 A.P65 10/08/2000, 07:39 5