TA Triumph-Adler FAX 930 - Manual (Page 33)

2 8
Default resolution for outgoing documents
If this parameter is activated, all documents you send out
will bear a header featuring your name, number, the date
and the page no.
Your fax machine supports several transmit speeds. Where
line conditions are good (adapted, no echo) transmission
usually takes place at a speed of 14400 baud.
However, transmission speeds must sometimes be limited
for certain sessions.
If this parameter is set, the unit will automatically damp
the echo on long distance calls.
On some long-distance calls (via satellite), the echo on the
line can hamper transmissions.
Choice between display of the number of the page currently
being transmitted and the transmission speed.
If this parameter is set, all incoming faxes will be printed
out with a header featuring the sender’s name and number
(if available), the date and the page no.
Your fax machine supports several receive speeds. Where
line conditions are good (adapted, no echo) reception
usually takes place at a speed of 14400 baud.
However, receive speeds must sometimes be limited for
certain sessions
The number of rings before your fax machine picks up the
call
Enables you to specify whether the memory has been
extended and the additional capacity (in pages)
You can change the Internet connection time slot for
periodic access (menu 9412), thus avoiding night-time
access
SCANNING MODE NORMAL MENU291 OK 1
FINE MENU291 OK 2
PHOTO MENU291 OK 3
TX HEADER WITH MENU292 OK 1
WITHOUT MENU292 OK 2
TX SPEED 14400 MENU293 OK 1
12000 MENU293 OK 2
9600 MENU293 OK 3
7200 MENU293 OK 4
4800 MENU293 OK 5
2400 MENU293 OK 6
ECHO PROTECT WITH MENU294 OK 1
WITHOUT MENU294 OK 2
EPT WITH MENU296 OK 1
MODE WITHOUT MENU296 OK 2
COM. DISPLAY SPEED MENU297 OK 1
PAGE NUMBER MENU297 OK 2
RX HEADER WITH MENU2910 OK 1
WITHOUT MENU2910 OK 2
RX SPEED 14400 MENU2911 OK 1
9600 MENU2911 OK 2
4800 MENU2911 OK 3
2400 MENU2911 OK 4
RINGS 2 to 5 MENU2912 OK
MEMORY EXT WITHOUT MENU2940 OK
+(x) p
NET VALID 6:01 21:59 MENU2970 OK
6. TECHNICAL PARAMETERS
You can adapt your fax machine to your specific requirements by setting the unit’s various technical parameters.
To set the technical parameters, press MENU followed by 2 and 9, then move the cursor to the required setting
and press OK to confirm.
Parameter Value Procedure Description
CH06 23228395-7.P65 10/08/2000, 07:42 28