TA Triumph-Adler FAX 930 - Manual (Page 12)

7
FITTING THE GAUGE AND THE TONER CARTRIDGE
h
i
1- Remove the card bearing the gauge (h) from its aluminium
packaging.
- Detach the gauge mini-smartcard (i) from the card.
2. Open the cover housing the scanning assembly by
simultaneously pressing on the buttons located on
either side.
Locate the panel housing the gauge.
j
3. Slide the panel (j) open and position the gauge mini-
smartcard (i) in its housing ensuring that the contacts
are facing outwards.
1
2 3
L
Unfurl the strip (L) of the black protective
sheath prior to fitting the photosensitive
drum.
4- Gently pull on the strip (L) of the black protective
sheath until the sheath has been completely
removed.
Should the black protective sheath tear, carefully remove
any remaining pieces.
G
FITTING THE PHOTOSENSITIVE DRUM
1- Open the cover housing the scanning assembly
by pressing simultaneously on the two buttons
located to either side.
2- Unpack the photosensitive drum.
Using the two handles, slot the right-hand-side
roller gear with its black protective sheath into
the runners (G)
2 1
3 4
L
CH00-01 23228395-7 A.P65 10/08/2000, 07:40 7