TA Triumph-Adler FAX 930 - Manual (Page 13)

8
8. Close the scanning assembly cover. Press down on both sides
of the cover to make sure that it locks into place.
8
6. Unclip the protective plastic guard of the toner
cartridge using the two tabs.
Carefully remove the plastic guard and the foam
gasket.
The foam gasket is attached to the plastic guard
at one end.
7. Hold the toner cartridge by the handle with the text
facing upwards.
Check that the photosensitive drum is in position,
otherwise refer to the previous section: fitting the
photosensitive drum.
Slot the toner cartridge into the unit along the lateral
guides (M).
Push the cartridge in firmly using the handle until it
slots into place.
M
M
6 7
i
4. Slide the panel back.
Ensure that the gauge mini-smartcard stays in
place while you slide the panel back.
5. Remove the toner cartridge from its aluminium
packaging.
Remove the strips of adhesive tape.
Gently shake the cartridge sideways 5-6 times to
distribute the toner evenly.
4 5
CH00-01 23228395-7 A.P65 10/08/2000, 07:40 8