TA Triumph-Adler CX 8020 - Manual (Page 4)

WARNING
Ground the product with a correct ground source or you may be electrically
shocked.
1. The Power source should be as follows:
220-240V plus 6% or minus 10%, 50/60Hz, 10A
2. Use a circuit with a dedicated breaker.
3. Install the product as close to the wall outlet as possible.
4. If you wish to move the machine, please contact your service personnel.
1. Do not remove the screw and do not open the cover if not instructed to
do so in this User’s Manual. If you ignore this warning, you may be burnt
or receive an electric shock due to a hot item or electrically charged part
inside of the printer.
2. Do not disassemble or tamper with the copier.
It may result in a fire or an electrical shock.
1. Do not plug in the machine into a multi-wire connector in which some
other equipment is plugged into.
It may cause a fire due to outlet overheating.
2. Do not damage the Power Cord by stepping on or placing heavy items
on it.
If the Power Cord is damaged, it may cause a fire or you may receive
an electric shock. REPLACE THE CORD IF DAMAGED!
1. Do not put a flower vase, a flowerpot or any water-filled item on the
product.
Spilt water could cause a fire or an electric shock.
2. If the product generates an abnormal smell or noise, turn it off and
unplug it from the wall electrical outlet immediately.
1. Do not throw toner (including wasted toner), toner cartridge and used
wasted toner bottle into a fire or other sources of heat, as it can
explode.
2. When you discard toner (including wasted toner), toner cartridge and
used wasted toner bottle, follow your service personnel’s instructions.
(3)