TA Triumph-Adler CX 8020 - Manual (Page 63)

4. 1. 1. 1 Code “J0” : Original Mis-feed
Mis-feed Code “J0” is indicated when the original is mis-fed
under the Original Feed Unit.
STAND BY
SL
LIGHTER DARKER
FILM
VELLUM/TRACING
PLAIN PAPER
MEDIA
ROLL
CUT SHEET
C
CLEAR DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
Rear Front
Remove the mis-fed original in the following direction.
1. Open the Original Feed Unit (1), and remove the
original.
2. Close the Original Feed Unit (1).
Chapter 4 Error Treatment 4-4
NOTE
“J0” is also indicated if you cancel copying in the middle pressing the STOP/ALL CLEAR
Key.
Please remove the original in the above shown direction in this case.
1