TA Triumph-Adler CX 8020 - Manual (Page 54)

3. 6 Power Saving Mode and Power OFF
Mode
You can enable the Power Saving Mode or the Power OFF Mode to save the power consumption
when the CX 8020 is not used for a long time.
3. 6. 1 Power Saving Mode
The Power Saving Mode is the function to reduce the power consume when you do not make any
operation for some period although you leave the CX 8020 ON.
You can work the Power Saving Mode manually or automatically.
3. 6. 1. 1 Power Saving Mode (Manual)
1. Press the STAND BY Key (1).
The Power Saving Mode works, so all the indications on
the Operation Panel are out.
To cancel the Power Saving Mode, press either
STAND BY Key or STOP / ALL CLEAR Key.
Chapter 3 Useful Function 3-11
STAND BY
SL
LIGHTER DARKER
FILM
VELLUM/TRACING
PLAIN PAPER
MEDIA
ROLL
CUT SHEET
C
CLEAR DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
1
sh.
The purpose of Power Saving Mode is to reduce the power consumption by reducing the
temperature of the fuser.
If you do not make any copy for the time you specified in advance, the machine automatically
goes into the Power Saving Mode so not to consume the power.
Or it is possible for you to make the machine go into the Power Saving Mode manually at
any time you wi
The Power Saving Mode will be cancelled if you press either STAND BY Key or STOP / ALL
CLEAR Key.
However please understand it may take time to recover from the Power Saving Mode
because it is necessary to heat up the fuser again.
(Copy is not available until CX 8020 becomes ready.)
Reference