TA Triumph-Adler CX 8020 - Manual (Page 55)

3. 6. 1. 2 Power Saving Mode (Automatic)
The Power Saving Mode automatically works if you do not make any copy for you specified in
advance.
1 1. Press the STAND BY Key (1) for 3 seconds.
The Indication Part (2) indicates “LP” (at first).
STAND BY
SL
LIGHTER DARKER
FILM
VELLUM/TRACING
PLAIN PAPER
MEDIA
ROLL
CUT SHEET
C
CLEAR DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
2. If you press the DECREASE Key or the INCREASE
Key (3), the Indication Part (2) indicates “LP” and “OF”
alternately.
“LP” means the Power Saving Mode
“OF” means the Power OFF Mode
As you will specify the timer for the Power Saving Mode
from now, indicate “LP”.
3. Press the STAND BY Key (1).
The Indication Part (2) indicates the present setting
of the timer of the Power Saving Mode.
2
3
4. Change the setting of timer pressing DECREASE Key and INCREASE Key (3).
The selectable values are 10, 30, 1h (1 hour), 2h and 4h.
DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
C
CLEAR
STOP
ALL CLEAR
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
3
NOTE
It is possible to cancel the setting if you press the STOP/ALL CLEAR Key (4) in the middle of
setting.
5. When you have finished all the settings, press the STAND BY Key (1).
If you leave the machine without any operation for the time you specified, the Power
Saving Mode works automatically.
To cancel the Power Saving Mode, press either STAND BY Key or STOP / ALL CLEAR Key.
Chapter 3 Useful Function 3-12