TA Triumph-Adler CX 8036 - Manual (Page 152)

Section 7 AutoCAD HDI Driver 7-14
5.1.4 Status
This region shows the current:
- roll width and type
- any misfeeds
- toner requirements
- standby mode of the printer
This is an active communication with the printer. Therefore the status is
shown at the desktop of the user rather than visiting the printer which
may be located at a distance from the user’s PC.
5.2 Plot Identification
The following features can be used in environments where job costing or
department allocations are required for prints on the system. They can also be
useful for print identification and print distribution as this information can be
placed in a header.
Please see the Appendix for advanced naming variables.
5.2.1 Requester / User Name
This button allows the user to select a predetermined User Name from a
drop down list or manually type the name. This field may be configured to
be mandatory and also password protected as set in the KIP Request
application.( see KIP Request Software Guide ) The drop down and
passwords themselves are also configured in the Request Software.
%Username may be used as an environment variable.
5.2.2
Job Number
This button allows the user to select a predetermined Job Number from a
drop down list or manually type the job number. This field may be
configured to be mandatory and also password protected as set in the
Request application.( see KIP Request Software Guide ) The drop down
and passwords themselves are also configured in the Request Software.
5.2.3
Description
This button allows the user to select a predetermined Description from a
drop down or manually type a description. This field may be configured to
be mandatory and also password protected as set in the Request
application.( see KIP Request Software Guide ) The drop down and
passwords themselves are also configured in the Request Software.