TA Triumph-Adler CX 8036 - Manual (Page 172)

Section 8 Request 8-16
2.5.2.3 Clip to Image Size
Crops the file data to the start of image data. Applied when the file designer has
saved the entire drawing area as part of the file. If an error “File Too Large To
Print,” occurs, clipping to Image Size is often the solution.
2.5.2.4 Use Round End Capping
This will set end capping on lines in vector files to
round ends instead of what has been specified in
the plot file’s Line Attribute command.
2.5.2.5 Turn Merge On
Enables the user to merge lines of different shades.
When not applied, the layers within the plot file determine
how lines merge on each other.
2.5.2.6 Raster Photo Mode
When a raster image has been embedded
within a plot file, Raster Photo Mode
should be used.
Raster Photo Mode can be applied to all
drawings, whether they contain raster
images or not. Some raster images may
wish to printed in 100% solid rather than
the original shading of the image.
2.5.2.7 Raster Density Level
This slide bar will modify the density level of the embedded raster image. The scale
range is from 0-100. The higher the number on the scale, the darker the image will
be. A density level can also be keyed into the text field.