TA Triumph-Adler CX 8036 - Manual (Page 189)

Section 8 Request 8-33
5. 0 Request Installation
5.1 Installation
Two methods are available to install the KIP Request software on a Windows workstation.
1) Use an installed and configured KIP Windows Driver to gain access to the
KIP Request Installer.
2) Use the Installation CD provided with the system.
5.1.1
Requirements
Workstation operation systems can be:
Windows 2000
Windows XP
Administrator access is also required to install the software.
5.1.1 Windows Driver Access
1) click on “Start”, then “Printers and Fax”, and locate the KIP Windows print Driver
in the list of installed printers. If you do not see a KIP printer you should now use
the CD Installation.
2) right click on the driver and select “Properties”.
3) On the “Device Settings” tab will be a “INSTALL KIP REQUEST” Button.
4) Double click on the button and follow the prompts. Please accept the default
settings for easy of configuration.
5.1.2 CD Installation
1) locate the Software CD and place in disk drive.
2) Browse CD for INSTALLATION and KIP Request.
3) Follow the prompts and select all defaults settings for easy of configuration.
5.1.3 First Time Run
After the software installation is complete, the application can be
run from the Desktop ( icon shown ) or from the “Start” ,then “All
Programs , then “KIP Programs”, KIP Request . It may take
several minutes for the first time launch as it attempts to find configured KIP
devices. ( see 5.2 Connection to KIP Printers )
5.1.3.1 Master Password
Upon starting Request for the first time it will ask for a MASTER PASSWORD.
This password allows access to the Prompt Settings ( accounting )
configurations. This password will be used by the department manager or
network administrator. Please key in a password noting that it will be required in
the future. Once set the password can not be changed.