TA Triumph-Adler CX 8036 - Manual (Page 195)

Section 8 Request 8-39
Time in seconds that Request software will wait to read status information
(roll information, error condition) from the printer.
PenDir=C:\Program Files\Windows Request\Pens\
Records and displays location of the ‘Pen table’ being used for printing.
LastPen=default.Pen
Records and displays the last pen used for file submission
LastDir=C:\IMAGES
Records and displays the last folder where the files were printed from.
DefaultRequester=%UserName
Shown here using an environment variable called UserName. You may also
enter information after the “=” that will be displayed in the REQUESTER field
each time the Software is started. Up to 30 characters may be used.
DefaultDistribution=%Distribution
Shown here using an environment variable called Distribution. You may also
enter information after the “=” that will be displayed in the DISTRIBUTION
field each time the Software is started. Up to 30 characters may be used.
DefaultDescription=%Description
Shown here using an environment variable called Description. You may also
enter information after the “=” that will be displayed in the DESCRIPTION
field each time the Software is started. Up to 30 characters may be used.
Prompt=Distribution
This line allows the user to customize the Distribution field name.
RequesterPrompt=Requester
This line allows the user to customize the Requester field name.
TextSize=0.10"
A KIP text header will be applied to raw files dropped into a monitor path.
This value determines the size of the header, in inches.
TextPos=0
A KIP text header will be applied to raw files dropped into a monitor path.
This value determines whether the header appears on the Leading Edge (0),
or Trailing Edge (1).
The next section above contains the paths to the internal programs that Unattend
uses to detect, convert, merge, and move files. If the required programs are not in these
default locations, a Runtime Error 53 (File Not Found) will occur.
ExportExe=C:\PROGRAMS\DS\MTP.EXE
ViewExe=C:\Programs\ultrav.exe
RemoteControlExe=C:\Programs\vncviewer.exe
Raster2Tlc=C:\Programs\DS\MTF.Exe
Vector2Tlc=C:\Programs\DS\MH2.Exe
CropExe=C:\Programs\Cropexe.Exe
TlcMergeExe=C:\Programs\DS\MI.exe
TiffViewer=
AutoRecognize=c:\programs\DS\MAD.exe