TA Triumph-Adler CX 8036 - Manual (Page 244)

- 2 -
b) The .PLT files created by the driver can be viewed within the Request
software and printed in collated sets with enhanced features like using stamps,
header information and Pen settings.
Setting up the HPGL-2 parameters to create KIP Printer ready data file
ƒ Using windows explorer, identify folder where MICROSTATION software
is installed.
ƒ Under the sub-folder ‘PLOTDRV’ select ‘IMRTL.PLT’. Open this file with
Windows ‘Notepad’.
ƒ Editing the “IMRTL.PLT” file:
The line that requires a change is marked below in bold.
For an example, we will assume that the MICROSTATION User requires
to print to a Printer. We will also assume the Computer name to
be “KIP-PPC”.
Method 2 : Direct Print
Since the Port would be set up automatically with the change as on the next
page, users would be able to use this driver (KIPGL.PLT) to create plot file
data directly to the KIP controller
Method 2 : Request Print
Generate the plot file data (.PLT) at any specified location on the system
using the method above. Use KIP Request to select the “.plt” files and submit
them for printing. File collation, stamping, header information addition, etc are
features the users could use while using the KIP Request software.