TA Triumph-Adler CX 8036 - Manual (Page 21)

Section 1 Basic Printer Functions 1-15
2. 1 Turning on
1. Ensure the system is plugged into a dedicated
wall outlet.
2. There is a Power Switch on the right side of
system.
Switch to the “ I ” position to turn on the system.
Power Switch
3. The Operation Panel commences to operate, and the Copy Mode Screen will appear in
approximately 1 minute. A Ready Indicator on the Copy Mode Screen will flash during the
warm up process.
Ready Indicator
4. When the Ready Indicator stops flashing, the system is ready to copy/scan/print.
WARNING
(1) Do not handle the Power Plug with wet hands, or you may receive an electrical shock.
(2) Make sure to ground the machine for your safety.
(3) Do not plug the printer into a multi-plug connector in which other devices are
plugged into. It may overheat the outlet and may result in a fire.
(4) The outlet must comply with 120V, plus 6% & minus 10%, 15A, and 50/60Hz