PLANET GSW-1602SF - Manual (Page 15)

User’s Manual of GSW-1602SF / GSW-2404SF
To press 5 seconds and release the RESET button. The GSW-1602SF / GSW-2404SF will back to
the factory default mode (Except IP address). Be sure that you backup the current configuration of
GSW-1602SF/GSW-2404SF; else the entire configuration will be erased when pressing the
“RESET” button.
2.1.3 Switch Rear Panel
The rear panel of the Web Smart Gigabit Switch indicates an AC inlet power socket, which accepts input power from 100
to 240V AC, 50-60Hz.
■ GSW-1602SF / GSW-2404SF
Figure 2-5 Rear Panel of GSW-1602SF / GSW-2404SF
■ AC Power Receptacle
For compatibility with electric service in most areas of the world, the Web Smart Switch’s power supply automatically
adjusts to line power in the range 100-240VAC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptalbe on the rear panel of the Web Smart Switch. Plug the
other end of the power cord into an electric service outlet then the power will be ready.
„
The device is a power-required device, it means, it will not work till it is powered. If your
networks should active all the time, please consider using UPS (Uninterrupted Power Supply)
for your device. It will prevent you from network data loss or network downtime.
„
In some area, installing a surge suppression device may also help to protect your Web Smart
Switch from being damaged by unregulated surge or current to the Switch or the power adapter.
-9-