PLANET SGS-5220-24T2X - Manual (Page 325)

Command Guide of SGS-5220-24T2X
4.20.62 show loop-protect
Command:
show loop-protect [ interface ( <port_type> [ <port_list> ] ) ]
show Show running system information
loop-protect Loop protection configuration
interface Interface status and configuration
Default:
N/A
Usage Guide:
To display the Loop protection information.
Example:
To display the Loop protection information for GigabitEthernet 1/1.
Switch # show loop-protect interface GigabitEthernet 1/1
Loop Protection Configuration
======================================
Loop Protection : Enable
Transmission Time : 2 sec
Shutdown Time : 2 sec
GigabitEthernet 1/1
------------------------------
Loop protect mode is enabled.
Actions are both of shutdown and log.
Transmit mode is enabled.
No loop.
The number of loops is 12390.
Time of last loop is at 1970-01-01T14:58:28+00:00
Status is down.
4.20.63 show mac address-table
Command:
show mac address-table [ conf | static | aging-time | { { learning | count } [ interface
( <port_type> [ <port_type_list> ] ) ] } | { address <mac_addr> [ vlan <vlan_id> ] } |
-325-