PLANET IGS-10020HPT - Manual (Page 230)

User’s Manual of IGS-10020PT / IGS-10020HPT
230
• Policy Value
When "Specific" is selected for the policy filter, you can enter a specific policy value.
The allowed range is 0 to 255.
• Policy Bitmask When "Specific" is selected for the policy filter, you can enter a specific policy bitmask.
The allowed range is 0x0 to 0xff.
•
Frame Type Select the frame type for this ACE. These frame types are mutually exclusive.

Any: Any frame can match this ACE.

Ethernet Type: Only Ethernet Type frames can match this ACE. The IEEE
802.3 describes the value of Length/Type Field specifications to be greater
than or equal to 1536 decimal (equal to 0600 hexadecimal).

ARP: Only ARP frames can match this ACE. Notice the ARP frames won't
match the ACE with ethernet type.

IPv4: Only IPv4 frames can match this ACE. Notice the IPv4 frames won't
match the ACE with ethernet type.
•
Action Specify the action to take with a frame that hits this ACE.

Permit: The frame that hits this ACE is granted permission for the ACE
operation.

Deny: The frame that hits this ACE is dropped.
•
Rate Limiter Specify the rate limiter in number of base units. The allowed range is 1 to 16. Disabled
indicates that the rate limiter operation is disabled.
• EVC Policer
Select whether EVC policer is enabled or disabled. The default value is "Disabled".
• EVC Policer ID
Select which EVC policer ID to apply on this ACE. The allowed values are Disabled or
the values 1 through 128.
• Port Redirect Frames that hit the ACE are redirected to the port number specified here. The allowed
range is the same as the switch port number range. Disabled indicates that the port
redirect operation is disabled.
• Mirror
Specify the mirror operation of this port. The allowed values are:

Enabled: Frames received on the port are mirrored.

Disabled: Frames received on the port are not mirrored.
The default value is "Disabled".
• Logging
Specify the logging operation of the ACE. The allowed values are:

Enabled: Frames matching the ACE are stored in the System Log.

Disabled: Frames matching the ACE are not logged.
Please note that the System Log memory size and logging rate is limited.
• Shutdown
Specify the port shut down operation of the ACE. The allowed values are:

Enabled: If a frame matches the ACE, the ingress port will be disabled.

Disabled: Port shut down is disabled for the ACE.
• Counter The counter indicates the number of times the ACE was hit by a frame.