2 install the industrial managed switch, 1 installation steps – PLANET IGS-10020HPT User Manual
Page 44
User’s Manual of IGS-10020PT / IGS-10020HPT
44
2.2 Install the Industrial Managed Switch
This section describes how to install the Industrial Managed Switch and make connections to it. Please read the following
topics and perform the procedures in the order being presented. To install your Industrial Managed Switch on a desktop or
shelf, simply complete the following steps.
In this paragraph, we will describe how to install the Industrial Managed Switch and the installation points attended to it.
2.2.1 Installation Steps
1.
Unpack the Industrial Managed Switch
2.
Check if the DIN-Rail is screwed on the Industrial Managed Switch or not
. If the DIN-Rail is not screwed on the
Industrial Managed Switch, please refer to DIN-Rail Mounting section for DIN-Rail installation. If users want to
wall-mount the Industrial Managed Switch, please refer to the Wall Mount Plate Mounting section for wall-mount plate
installation.
3.
To hang the Industrial Managed Switch on the DIN-Rail track or wall.
4.
Power on the Industrial Managed Switch
. Please refer to the Wiring the Power Inputs section for knowing the
information about how to wire the power. The power LED on the Industrial Managed Switch will light up. Please refer to
the LED Indicators section for indication of LED lights.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet connection.
6.
Insert one side of RJ-45 cable (category 5) into the Industrial Managed Switch Ethernet port
(RJ-45 port) and another
side of RJ-45 cable (category 5) to the network device’s Ethernet port (RJ-45 port), ex: Switch PC or Server. The UTP port
(RJ-45) LED on the Industrial Managed Switch will light up when the cable is connected with the network device. Please
refer to the LED Indicators section for LED light indication.
Make sure that the connected network devices support MDI/MDI-X if it does not support, or
use the crossover category-5 cable.
7.
When all connections are set and LED lights all show normal, the installation is completed.