Set action, Read table action, Add table row action – PLANET MAP-3020 User Manual
Page 45: Delete table row action, Snmp walk action
PLANET Mesh Network Manager Guide
PLANET Mesh Network Manager Guide
Page 45 of 126
1.
Select any tree node (make sure it is either read-only or read-write type)
2.
Fill in the required parameter according to the version of SNMP to use.
3.
Click the SnmpGet button on the toolbar.
4.
The output should now display at the Output area.
• Set Action
1.
Select any tree node (only read-write type)
2.
Fill in the required parameter according to the version of SNMP to use.
3.
Enter the value to be set at the Input Value column. You may refer the Syntax
column to ensure the type of the input (eg: Integer, DisplayString..).
4.
Click the SnmpSet button on the toolbar.
5.
The Output area will display the result of the action, either “(Set
Successfully…)” or “(Set Failed…)”.
• Read Table Action
1.
Select a table tree node
2.
Fill in the required parameter according to the version of SNMP to use.
3.
Click the Load Table button on the toolbar.
4.
The Output field should display the whole table now.
5.
Use the Refresh Table to reload the table.
• Add Table Row Action
1.
Repeat the first three steps of Read Table Action
2.
Then enter the table values in the Input Value field. Values are separated by
a comma (,). (see the following figure)
3.
Click the Add Table Row button on the toolbar.
4.
The new entry should be added to the table.
• Delete Table Row Action
1.
Repeat the first three steps of Read Table Action
2.
Select the entry that you wish to remove from the table.
3.
Click the Delete Row button on the toolbar.
4.
A popup window would appear to ask for your confirmation to delete the
selected entry. Hit OK to proceed.
5.
The selected entry should be removed from the table.
• Snmp Walk Action
1.
Select any tree node. (It can be a table, scalar or even the main node)
2.
Fill in the required parameter according to the version of SNMP to use.