PLANET MAP-3020 - Manual (Page 90)

PLANET Mesh Network Manager Guide
PLANET Mesh Network Manager Guide Page 90 of 126
5) Enable Hysteresis
• A checkbox to enable the hysteresis of the Mesh AP
• Link hysteresis determines the criteria at which a link to a neighbour is
accepted or rejected. Hysteresis adds more robustness to the link sensing,
but delays the neighbour registration.
6) Hysteresis Scaling
• The level scale of the hysteresis
• Data type: Float (0.0 ~ 1.0)
7) Hysteresis THR High
• The upper limit (threshold high) of the hysteresis
• Data type: Float (0.0 ~ 1.0)
8) Hysteresis THR Low
• The lower limit (threshold low) of the hysteresis
• Data type: Float (0.0 ~ 1.0)
9) Link Quality Type
• The type of link quality
• Available options:
o Disable
o Use for MPR selection
o Use for MPR selection and Routing
10) Link Quality Size
• The Link quality window size
• Data type: Integer, default size is 10
11) Poll Rate
• The polling rate, where the value is in the interval of 0 and 1
• Data type: Float
12) TC Rate
• The TC redundancy specifies the level of neighbour information should be
sent in a TC message.
• Available options: