ProSoft Technology PTQ-104C - Manual (Page 63)

49TPTQ-104C ♦ 48TQuantum Platform Module Configuration
47TIEC 60870-5-104 Client
12TUser Manual
5.6.1 [IEC-104 Client/Session x > IEC-104 Client x] section
Item Range Description
Server IP Address IP dotted
notation IP address for the server to connect this client to
with 0.0.0.0 used to disable the client.
Sector Count 1 or 2 This parameter sets the number of sectors
contained in this controlled device. The range of
values is from 1 to 2. A sector section is required
for each sector in a session to define its database
and settings.
T0 timeout 1 to 30 Number of seconds to wait for connection to be
established with server in seconds (default=30)
T1 timeout 1 to 255 Number of seconds until a timeout occurs to send
or test APDU's (Application Protocol Data Units)
(default = 15)
T2 timeout 1 to 255 Number of seconds until timeout for non-data
acknowledgement (t2 < t1) (default=10)
T3 timeout 1 to 300 Timeout for test frame on idle state in seconds
(default=20)
k (maximum queue) 1 to 12 Maximum number of messages to hold in queue
w (latest ack threshold) 1 to 8 Threshold value when to send ack. This
parameter should be less than or equal to two-
thirds of k.
Originator address for
COT 0 to 255 Originator address in the COT (Cause of
Transmission) to use in all messages from the
client
Response Timeout 500 to 2^32-1 This parameter sets the maximum number of
milliseconds to wait for a confirmation from the
controlled station to a request from this module to
application level messages.
ProSoft Technology, Inc. Page 63 of 136
March 4, 2013