Sony Cyber-shot RX10 III - Manual (Page 117)

[Sweep Panorama]
When [ISO] is set to a value lower than ISO 100, the range for recordable subject
brightness (dynamic range) may decrease.
The higher the ISO value, the more noise will appear on the images.
The available ISO settings will differ depending on whether you are shooting still images,
shooting movies, or using HFR.
When shooting movies, ISO values between ISO 100 and ISO 12800 are available. If the
ISO value is set to a value smaller than ISO 100, the setting is automatically switched to
ISO 100. When you finish recording the movie, the ISO value returns to the original
setting.
When you use [Multi Frame NR], it takes some time for the product to perform the overlay
processing of images.
Hint
You can change the automatically set ISO sensitivity range for the [ISO AUTO] mode.
Select [ISO AUTO] and press the right side of the control wheel, and set the desired
values for [ISO AUTO Maximum] and [ISO AUTO Minimum]. The values for [ISO AUTO
Maximum] and [ISO AUTO Minimum] are also applied when shooting in [ISO AUTO]
mode under [Multi Frame NR].
[106] How to Use Using shooting functions Selecting the ISO sensitivity
ISO AUTO Min. SS
If you select [ISO AUTO] or [ISO AUTO] under [Multi Frame NR] when the shooting mode is
P (Program Auto) or A (Aperture Priority), you can set the shutter speed at which the ISO
sensitivity starts changing.
This function is effective for shooting moving subjects. You can minimize subject blurring
while also preventing camera shake.
1.
MENU→
(Camera Settings
)→[ISO AUTO Min. SS]→desired setting.
Menu item details
FASTER (Faster)/FAST (Fast):
The ISO sensitivity will start to change at shutter speeds faster than [Standard], so you can
prevent camera shake and subject blurring.
STD (Standard):
The camera automatically sets the shutter speed based on the focal length of the lens.
SLOW (Slow)/SLOWER (Slower):
The ISO sensitivity will start to change at shutter speeds slower than [Standard], so you can