Sony Cyber-shot RX10 III - Manual (Page 188)

TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1.
MENU →
(Setup
) → [TC/UB Settings] → [TC Preset], then press
in the center
of the control wheel.
2. Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
*
When [24p] is selected, you can select the last two digits of the time code in
multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3. Set the other digits following the same procedure as in step 2, then press in the
center of the control wheel.
How to reset the time code
1.
MENU →
(Setup
) → [TC/UB Settings] →[TC Preset], then press
in the center
of the control wheel.
2. Press the (Delete) button to reset the time code (00:00:00:00).
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander
(sold separately).
How to set the user bit (UB Preset)
1.
MENU →
(Setup
) → [TC/UB Settings] → [UB Preset], then press
in the center
of the control wheel.
2. Turn the control wheel and select the first two digits.
3. Set the other digits following the same procedure as in step 2, then press in the
center of the control wheel.
How to reset the user bit
1.
MENU →
(Setup
) → [TC/UB Settings] → [UB Preset], then press
in the center
of the control wheel.
2. Press the (Delete) button to reset the user bit (00 00 00 00).
How to select the recording method for the time code (TC
Format
*1
)
1.
MENU →
(Setup
) → [TC/UB Settings] → [TC Format], then press
in the