Sony Cyber-shot RX10 III - Manual (Page 34)

1. Turn the power off.
2. Connect the camera with the battery pack inserted to the AC Adaptor (supplied) using
the micro USB cable (supplied), and connect the AC Adaptor to the wall outlet (wall
socket).
Charge lamp
Lit: Charging
Off: Charging finished
Flashing: Charging error or charging paused temporarily because the camera is not
within the proper temperature range
If the charge lamp lights up once and then immediately turns off, the battery pack is
fully charged.
Charging time (Full charge)
The charging time is approximately 150 min. using the AC Adaptor (supplied).
The charging time may differ depending on the remaining capacity of the battery pack or
the charging conditions.
The battery pack can be charged even when it is not fully depleted.
The above charging time applies when charging a fully depleted battery pack (supplied) at
a temperature of 25°C (77°F). Charging may take longer depending on the conditions of
use and the environment.
Note
If the charge lamp flashes when the battery pack is not fully charged, remove the battery
pack or disconnect the USB cable from the camera and then re-insert it to recharge.
If the charge lamp on the camera flashes when the AC Adaptor is connected to the wall
outlet (wall socket), this indicates that charging is temporarily stopped because the
temperature is outside the recommended range. When the temperature gets back within
the appropriate range, the charging resumes. We recommend charging the battery pack
at an ambient temperature of between 10°C to 30°C (50ºF to 86ºF).
Use a nearby wall outlet (wall socket) when using the supplied or recommended AC
Adaptor/battery charger. If any malfunction occurs while using this product, disconnect the
plug from the wall outlet (wall socket) immediately to disconnect from the power source. If