Sun Microsystems 6900 - Manual (Page 187)

Appendix B Configuration Utility Error Messages 167
Sun Proprietary/Confidential: Internal Use Only
restorevemap • The import zone data failed.
• The restore physical and logical
data failed.
• The restore zone data failed. 1. Check the status of both
virtualization engines.
2. If an error condition exists, refer
to Appendix A for corrective
action.
3. Run the restorevemap
command again.
setdefaultconfig • The virtualization engine is unable
to properly configure the
virtualization engine host
${vehost} .
• The virtualization engine cannot
continue the configuration of other
components.
1. Check the status of the
virtualization engine and reset, if
necessary.
2. Run the setdefaultconfig
command again.
setdefaultconfig The setupve (1M) command failed. 1. Run setupve -n ve_hostname
-v (verbose mode).
2. Check the errors.
3. Run
checkve -n
ve_hostname .
You can continue to configure
VLUNs and zones only if both of
these commands work.
TABLE B-1 Virtualization Engine Error Messages (Continued)
Source of Error Message Cause of Error Message Suggested Corrective Action