Sun Microsystems 6900 - Manual (Page 99)

Chapter 7 Troubleshooting Switches 79
Sun Proprietary/Confidential: Internal Use Only
chassis.
zone Alarm Yellow “Switch sw1a was rezoned”
This event reports changes
in the zoning of a switch.
enclosure Audit “Auditing a new switch
called
ras d2-swb1
(ip=xxx.0.0.41)
10002000007a609”
oob Comm_
Established “Communication regained
with
sw1a
(ip= xxx. 20.67.213)”
oob Comm_
Lost Down Y “Lost communication with
sw1a
( ip=xxx.20.67.213 )”
Ethernet connectivity to the
switch has been lost.
1. Check Ethernet
connectivity to the
switch.
2. Verify that the switch is
booted correctly with no
POST errors.
3. Verify that the switch
Test Mode is set for
normal operations.
4. Verify the TCP/IP
settings on switch by
way of Forced PROM
Mode access.
5. Replace switch, if
needed.
switch
test
Diagnostic
Test- Red Check Test Manager for
failure details.
TABLE 7-1 Storage Automated Diagnostic Environment Event Grid for 1 Gbit Switches (Continued)
Component EventT
ype
Se
verity
Action Description Note: T
e
xt
within
quotation
marks
(“
“)
is
e
xactl
y
as
it
appear
s
o
n
the
Event
Grid.
Action Required