Sun Microsystems 6900 - Manual (Page 124)

104 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
disk State
Change- Red Y The Sun StorEdge T3+
array has reported that a
disk has failed. 1. Open a Telnet session
to the affected Sun
StorEdge T3+ array.
2. Verify the disk state
with vol_stat ,
fru_stat , and
fru_list .
Drive Status Messages:
0 Drive mounted
2 Drive present
3 Drive is spun up
4 Drive is disabled
5 Drive has been
replaced
7 Invalid system area on
drive
9 Drive not present
D Drive disabled; is
being reconstructed
S Drive substituted
3. Replace the disk if
necessary.
interface.
loopcard State
Change- Red Y The Sun StorEdge T3+
array has indicated that
the loopcard is no longer
in an optimal state. 1. Open a Telnet session
to the affected Sun
StorEdge T3+ array.
2. Verify loopcard state
with fru stat .
3. Verify matching
firmware with other
loopcard.
4. Reenable the
loopcard, if possible
with: (enable
u(encid)|[1|2|])
5. Replace the loopcard,
if necessary.
TABLE 8-1 Storage Automated Diagnostic Environment Event Grid for the Sun StorEdge T3+ Array
Component Event
T
ype
Se
verity
Action Description Action